I'm gonna have to figure out how the inducive switch on my 3D-printer works, so I can wire it up to my new controller board....
that sounds easy, until you realize there are no markings indicating what kind of switch it is exactly.... and I don't know all that much about electronics let alone inductive switches.
@la like an endstop? or a eddy current bed probe
@noiob like an endstop
@la 5 is almost 6… right
@noiob It might work anyhow, and that's how I wired it for now, but I'm pretty sure it's not "correct"
@la I mean if it works
@noiob most of the ones I found online have a speced input voltage range of 6-36V. And the Ramps board should supply 5V to the switches, If I understood i right.