Currently going for another sub-30 benchy. But of course my max acceleration is lower, given the increased weight of the toolhead. So now I'm running faster speeds, and therefor faster extrusion, so I'm heating my nozzle a bit further, and so now there's more heat in my print, and so now there's a need for more cooling, but I think my cooling is infact worse than before so quality is suffering.
But at reasonable speeds and with reasonable prints it should overall be better.
28:19 actual print time (probably about half a minute is moving to Z-max at the end)
@la just replace that in the ending gcode ^
@noiob yea, but how do I make it move Z *just* another 2mm or so up. I'm sure that's suuuper easy to figure out, but do I actually care? (I do not)
G91
G1 Z10
@la well, this is 10mm but younger the idea. I think 2 mm might be too little to get the nozzle out of the way anyways
