katt, migrating 🌟 🌈 @starkatt@awoo.space

Y'know,

doing my own code for this project means I can 100% make it light up in trans pride colors.

Nice.

Going with a taped construction instead of a glued/tabbed construction plus not doing layers of decorative finish paper made this go MUCH faster than the first build.

Made a new blank to use as a mold.

Ended up going with 110% scaling factor which was probably a bit too much. The eye hole spacing is a bit weird. Still, probably the kind of thing that nobody but me will notice.

Hmm, apparently when I made V1 (paper) it was scaled at 96% due to A4/US-Letter discrepencies. I'm gonna print this one at 105% to give a little more room for electronics.

Status: fox rapidly bouncing up and down in place while yapping "art!" over and over.

@masklayer I've not experienced this but I'm gonna try it now.

@CoronaCoreanici just people requesting follow and clearly not reading "introduce yourself first".

@Aradia@mastodon.social Shit. Best of luck, fox friend.

@trysdyn Not you :)

For fuck's sake though, really, what is with people and not reading bios before following.

@shoofle honestly I'd say don't do it unless you're absolutely sure? It IS a big responsibility.

@sev just placed a hold on a copy :)

@sev I haven't!

@catoxis @Kyresti @indi they're not EDM-specific, but Kremwerk and Re-Bar are my favorite queer clubs.

@emanate @CoronaCoreanici @indi no the sparklers were the more objectionable part of that for me. I still had a good time at that show, even with the obnoxious venue and crowd :)