@rey @typhlosion cutting the pin is probably safer and easier; when you need to remove a DIP IC and you don't need it to remain functional that's usually the best way to do it is just cut all the pins then desolder them one by one

you do need the 10NES to remain functional but not this one pin; I think there's other stuff that stops the system working if the 10NES is removed completely. i believe the pin you remove is just the one that connects to the reset signal

-F

@rey @typhlosion could be an impetus for you to get some side cutters though! you'd certainly have more use for them outside this project than kassy, who i don't know if she plans to do much hardware work, though i don't want to put words in her mouth of course
-F

@Felthry @rey i would love to get more into this stuff! though i dont really have a workspace for hardware stuff yet.

i did manage to mutilate pin 4 all the way off the 10nes chip somehow. pic attached (mild hardware gore i guess??). um. hopefully that will work??? im honestly kind of really scared, lmao.

@typhlosion @rey Looks like you've done the job there honestly! it's very hard to damage the chip inside by doing anything to the pins on the outside
-F

@Felthry @rey im less worried about damaging the chip inside and more worried about the sheer artlessness of the way i did it having knock-on effects, or of having picked the wrong pin or such

@typhlosion @rey Nope! That is indeed pin 4, and the only possible knock-on effect would be if some metal fragments bridge other pins; just give it a good brushing or even a spray from a can duster to get rid of any of those
-F