shork @noiob@awoo.space

remember Algebra Graph? this is him now, feel old yet?

@la well, there's only one solution: a complex pulley and lever system to lower it from the ceiling when you need it

@Natanox oh, and it kinda looks like the first layer is getting blown away by part cooling, maybe turning that off in the first layer would help (though it'd only be a stopgap vs better bed adhesion)

@la does it have to be there but can it be in a less knockoffable location

@elilla some even have coffee cake with their coffee

@elilla Kaffee und Kuchen, I feel like I could vibe with the Finns

@Natanox do you have a bed probe? I suspect your build plate is not exactly flat

@Natanox aside, but isoprop just moves fats around, I recommend soapy water for a thorough clean

@Natanox does slowing down the initial layer much more do anything? I wonder if the perimeters stick because they get printed much slower. I'd also try just adjusting z-height 0.02 mm down to squish it further down, in Klipper you can just adjust it on the fly until it looks right

also never a bad idea to clean the build plate. is that PEI?

@bea oh that rules

@root42 okay fair that might be a problem

@bea sorry, the what?

@LANthus wait so there will be two different Galaxy 1 releases on the Switch, that's just silly

@root42 consider contacting Apple support, they've been very helpful the few times I opened a chat, even when my at that time pretty old iPhone 3GS wouldn't sync properly

@la absolutely not